FARGO Electronics DTC, DTC, DTC, DTC DTC color id printers, 10 Cleaning Cards, 10 Cleaning Pads, 10 cleaning tapes, full instructions. FARGO Electronics DTC, DTC, DTC, DTC DTC color id printers, DTC/ Dual hopper; PVC cards “); auto or manual feed. HID GLOBAL, HID, the HID logo, FARGO, and iCLASS, are .. installed and used in accordance with the instruction manual, may cause.

Author: Kazrale Mikajind
Country: Burma
Language: English (Spanish)
Genre: Photos
Published (Last): 18 November 2018
Pages: 180
PDF File Size: 14.30 Mb
ePub File Size: 15.1 Mb
ISBN: 749-3-18660-215-1
Downloads: 33498
Price: Free* [*Free Regsitration Required]
Uploader: Dijind

See the Replacing the Flipper Home Sensor procedure on the next page.

Fargo DTC Thermal Printer Manual & User Guide – Fixya

The take-up end is the other side. Page of Go.

Select this option to shift the recorded magnetic data to the left-hand side of the card’s Magnetic Stripe. Select Landscape to cause the card to print in a horizontal orientation, as shown on the below.


Do not select this option, and the Printer’s memory will Buffer as many print jobs farg possible until the Printer’s memory is full. Re-install the printing supplies. Select No Parity to change the Character Parity to none.

  AT HD570 PDF

When you remove the Printhead, you can see the circled area, as shown in the photo below. If necessary, adjust the Internal Card Guide as described in the dfc515 of this section.

Replace the Sensor if the voltages are incorrect. The second page of the document will then be printed on the back of a second card.

Using the Encoding Mode option continued See the previous procedure in this section.

FARGO Electronics DTC500 Series Troubleshooting Manual

Printers with this option include an RS serial port. Page – Using the Rotate Back by Degrees opt Decompress the file by double-clicking on ffargo designated icon.

Printing A Test Image Note: Replacing The Main Board d 3 Circuit Board mounting screws located at manuao left, middle and right sections. Resolving The Dram Memory Error Replacing the Printhead Assembly continued Compress these 2 springs to remove the Printhead, as shown below.

When this occurs, press the Cancel soft key to manually eject the mistakenly verified card. Don’t show me this message again.


Replace the Main Board. This is the discharge end of the Printer. Don’t have an account?

Select either the inches or mm radio button as needed. The following describes these options and the Printer’s magnetic encoding process. The LCD will prompt: If a small or low-resolution image is stretched or blown up, a pixilated or grainy effect will occur when printing, as shown below. Page 65 – Replacing the Flipper Home Sensor Are you sure you want to continue?

Fargo DTC500 Specifications

The image consists of sixteen 16 gray scale boxes and alignment arrows. See the previous procedure in this fzrgo. It is not possible to apply an overlay and a SmartShield image to the same side of a card. Press the Reset button to clear the entire existing error log and start a new log.